Under Sink Grease Trap Installation

Grease traps are essential for preventing grease and other solids from entering your plumbing system. This can lead to clogs, backups, and expensive repairs. Under sink grease traps are a great way to keep your drains clear and your plumbing system running smoothly.

Installing an under sink grease trap is a relatively simple process that can be completed in a few hours. Here are the steps involved:

Gather your materials. You will need the following items:

Under sink grease trap
Pliers
Wrench
Teflon tape
Bucket

Choose a location for the grease trap. The grease trap should be installed under the sink, as close to the drain as possible. Make sure there is enough space for the trap to fit comfortably.
Turn off the water supply to the sink. This will prevent water from leaking out of the trap when you remove the drain.
Disconnect the drain from the sink. Use a wrench to loosen the nuts that hold the drain in place. Be careful not to overtighten the nuts, as this can damage the threads.
Install the grease trap. Place the grease trap over the drain and tighten the nuts. Make sure the trap is level and that the inlet and outlet pipes are facing the correct direction.
Connect the drain to the grease trap. Use a wrench to tighten the nuts that hold the drain to the trap. Be sure to use Teflon tape on the threads to prevent leaks.
Turn on the water supply to the sink. Check for leaks around the grease trap. If there are any leaks, tighten the nuts until the leaks stop.

Once the grease trap is installed, it is important to clean it regularly. This will prevent grease and other solids from building up and causing clogs. To clean the grease trap, simply remove the cover and empty the contents into a bucket. Rinse the trap with water and replace the cover.

Under sink grease traps are an easy and effective way to keep your drains clear and your plumbing system running smoothly. By following the steps above, you can install a grease trap in just a few hours.