Installing A Bathroom Sink Faucet

Replacing a bathroom sink faucet is a relatively simple plumbing project that even a beginner can do with the right tools and a little patience. Here's a step-by-step guide to walk you through the process:

Gather Your Tools and Materials

Before you start, gather the following tools and materials:

New bathroom sink faucet
Adjustable wrench
Pliers
Basin wrench
Plumber's putty
Teflon tape
Bucket or basin
Screwdriver

Turn Off the Water Supply

Start by turning off the water supply to the sink. There should be two shut-off valves beneath the sink, one for hot water and one for cold water. Turn both valves clockwise to close them.

Disconnect the Old Faucet

Use the adjustable wrench to loosen the nuts that connect the water supply lines to the old faucet. Disconnect the lines and place them in the bucket or basin to catch any residual water.

Next, use the basin wrench to loosen the mounting nuts that hold the faucet in place. Carefully lift the old faucet out of the sink.

Clean the Sink Surface

Before installing the new faucet, clean the sink surface around the faucet holes to remove any old sealant or debris.

Install the New Faucet

Apply a bead of plumber's putty around the base of the new faucet. Place the faucet in the holes and tighten the mounting nuts by hand until they are snug.

Wrap Teflon tape around the threads of the water supply lines. Connect the lines to the corresponding inlets on the faucet and tighten them using the adjustable wrench.

Use the screwdriver to tighten the handle screws.

Turn On the Water Supply and Check for Leaks

Slowly turn on the water supply valves beneath the sink and check for any leaks. If you see any leaks, tighten the connections or adjust the plumber's putty as needed.

Once everything is secure and leak-free, your new bathroom sink faucet is ready to use.