How To Put Kitchen Sink - Sink Remodels

How to Install a Kitchen Sink

A new kitchen sink can change the entire look and feel of your kitchen. It’s a relatively easy project that can be completed in an afternoon, and it doesn’t require any special skills. Here’s a step-by-step guide on how to install your new kitchen sink.

1. Tools and Materials

Before you begin, gather the following tools and materials:

New kitchen sink
3/4-inch wrench
Phillips screwdriver
Plumber’s putty
Caulk gun
Utility knife
Measuring tape
Level
Bucket
Sponge

2. Remove the Old Sink

Start by turning off the water supply to your sink. Then, using a 3/4-inch wrench, disconnect the water supply lines from the faucet. Once the water lines are disconnected, you can remove the old sink by unscrewing the mounting nuts that are located under the sink. Carefully lift the old sink out of the hole in the countertop.

3. Clean the Countertop

Once the old sink is removed, clean the countertop thoroughly with a damp sponge and some dish soap. This will remove any dirt or debris that could prevent the new sink from sealing properly.

4. Apply Plumber’s Putty

Roll out a rope of plumber’s putty and place it around the rim of the new sink. The plumber’s putty will help to create a seal between the sink and the countertop.

5. Install the Sink

Carefully place the new sink into the hole in the countertop. Make sure that the sink is level and that the plumber’s putty is擠出between the sink and the countertop. Tighten the mounting nuts under the sink to secure the sink in place.

6. Reconnect the Water Lines

Using a 3/4-inch wrench, reconnect the water supply lines to the faucet. Turn on the water supply and check for leaks. If you find any leaks, tighten the nuts until the leaks stop.

7. Caulk the Sink

To prevent water from seeping between the sink and the countertop, apply a bead of caulk around the seam. Use a utility knife to trim any excess caulk.