How To Fit Kitchen Sink

Fitting a kitchen sink is a relatively simple task that can be completed in a few hours. By following these step-by-step instructions, you can save yourself the cost of hiring a plumber.

Tools and materials you will need:

New kitchen sink
Wrench
Plumber's putty
Caulk gun
Caulk
Level
Tape measure
Pencil

Step 1: Remove the old sink

Start by turning off the water supply to the sink. Then, disconnect the water lines from the sink. Next, use a wrench to loosen the nuts that hold the sink in place. Once the nuts are loose, you can lift the sink out of the countertop.

Step 2: Clean the countertop

Once the old sink is removed, take some time to clean the countertop. This will help to ensure that the new sink will fit properly.

Step 3: Install the new sink

Place the new sink in the hole in the countertop. Use a level to make sure that the sink is level. Once the sink is level, tighten the nuts that hold it in place.

Step 4: Connect the water lines

Connect the water lines to the sink. Make sure to use plumber's putty around the base of the water lines to prevent leaks.

Step 5: Caulk around the sink

Apply a bead of caulk around the edge of the sink. This will help to seal the sink and prevent water from leaking out.

Step 6: Turn on the water supply

Turn on the water supply to the sink. Check for leaks around the sink and water lines. If you find any leaks, tighten the nuts or caulk the area around the leak.