Hooking Up A Sink Drain

Installing a sink drain is a relatively simple plumbing task that can be completed in a few hours. By following these instructions, you can save yourself the cost of hiring a plumber.

Tools and Materials

Adjustable wrench
Plumber's putty
Sink drain
Sink strainer
Teflon tape

Instructions

1. Turn off the water supply to the sink. To do this, locate the shut-off valves under the sink and turn them clockwise until they are fully closed.

2. Place a bucket under the sink to catch any water that may leak out.

3. Use an adjustable wrench to loosen the nuts that hold the old drain in place. Be careful not to overtighten the nuts, as this could damage the sink.

4. Remove the old drain and discard it.

5. Apply a bead of plumber's putty around the base of the new drain. This will help to create a watertight seal.

6. Insert the new drain into the sink hole and tighten the nuts until they are snug.

7. Apply Teflon tape to the threads of the sink strainer. This will help to prevent leaks.

8. Screw the sink strainer onto the drain.

9. Turn on the water supply to the sink and check for leaks. If there are any leaks, tighten the nuts or the sink strainer until the leaks stop.

Tips

If you are having difficulty getting the drain to fit, try using a little bit of dish soap to lubricate the threads.
Be careful not to overtighten the nuts, as this could damage the sink.
If you are not comfortable working with plumbing, it is best to call a plumber.