How To Replace Stopper In Bathroom Sink

How to Replace a Stopper in a Bathroom Sink

A bathroom sink stopper is a small but important part that can prevent water from draining out of the sink. If your stopper is damaged or missing, it can be a nuisance and can even lead to water damage. Replacing a sink stopper is a relatively simple task that can be completed in a few minutes with a few basic tools.

To replace a sink stopper, you will need the following tools:

A new sink stopper
A pair of pliers
A screwdriver

Once you have gathered your tools, follow these steps to replace the sink stopper:

1. Turn off the water supply to the sink. This is usually done by turning the handles on the water supply valves under the sink.

2. Remove the old sink stopper. Most sink stoppers are held in place by a screw or nut. Use the pliers to loosen the screw or nut, then pull the stopper out of the drain.

3. Clean the drain. Once the stopper is removed, take a moment to clean the drain. Remove any hair, soap scum, or other debris that may have accumulated in the drain.

4. Install the new sink stopper. Insert the new sink stopper into the drain. Make sure that the stopper is properly seated in the drain, then tighten the screw or nut to secure it in place.

5. Turn on the water supply to the sink. Check for leaks around the stopper. If there are any leaks, tighten the screw or nut further.

Replacing a sink stopper is a simple task that can be completed in a few minutes. By following these steps, you can keep your sink draining properly and prevent water damage.