How To Change A Sink Stopper

A sink stopper is a small device that is used to plug the drain hole in a sink. It is typically made of rubber or plastic and is inserted into the drain hole from the top. Sink stoppers are available in a variety of shapes and sizes, and they can be either fixed or removable. Fixed sink stoppers are permanently attached to the sink, while removable sink stoppers can be taken out and cleaned as needed.

If your sink stopper is not working properly, it may need to be replaced. Replacing a sink stopper is a relatively easy task that can be completed in a few minutes. Here are the steps on how to change a sink stopper:

1. Remove the old sink stopper.

If your sink stopper is fixed, you will need to use a screwdriver to remove it. Insert the screwdriver into the screw that is holding the stopper in place and turn it counterclockwise. Once the screw is removed, you should be able to pull the stopper out of the drain hole.

If your sink stopper is removable, simply pull it out of the drain hole.

2. Clean the drain hole.

Once the old sink stopper has been removed, take a few minutes to clean the drain hole. Use a sponge or a brush to remove any debris that may have accumulated in the hole. You can also use a drain cleaner to help dissolve any clogs.

3. Insert the new sink stopper.

Once the drain hole is clean, insert the new sink stopper into the hole. If the stopper is fixed, use a screwdriver to tighten the screw that holds it in place. If the stopper is removable, simply press it into the hole until it is snug.

4. Test the sink stopper.

Once the new sink stopper is in place, test it to make sure that it is working properly. Fill the sink with water and then plug the drain hole with the stopper. The water should stop flowing out of the drain hole. If the water continues to flow out, the stopper may not be properly seated.

5. Clean the sink stopper regularly.

To keep your sink stopper working properly, it is important to clean it regularly. Remove the stopper from the drain hole and wash it with soap and water. You can also soak the stopper in a solution of bleach and water to help kill bacteria.

By following these steps, you can easily change a sink stopper. This is a simple task that can help to keep your sink working properly and looking its best.